Honda/Acura clips can be very difficult to remove. The problem is you cannot push in on one part of the clip and remove it, you must push in on both prongs of the clip at the same time. Honda/Acura makes so many different style clips that a clip tool which will work on one vehicle will not necessarily work on another vehicle.

The corners on today’s mouldings will often raise up and leave an unsightly gap under them. Taping these mouldings down can be disastrous because the tape will sometimes attack the paint and, in the worst case, remove it. Our moulding hold down tool is attached with a vacuum.

MAKE YOUR OWN MOULDINGS…Many vehicles still use mouldings that have “square” corners. Now you can make your own mouldings. Place your universal moulding on the lower jaw of the moulding cutters and squeeze the handle. A sharp utility knife blade cuts the moulding straight, smooth and at the proper angle.

To use the Underside Moulding Installer, push the moulding through the handle as shown (Fig. A) and then roll it along the edge of the glass (Fig. B), pushing downward (to set the adhesive) and inward against the edge of the glass (to keep the moulding a consistent distance from the outside edge). It is made of a heavy-duty plastic material and will give you years of carefree service.