Honda/Acura clips can be very difficult to remove. The problem is you cannot push in on one part of the clip and remove it, you must push in on both prongs of the clip at the same time. Honda/Acura makes so many different style clips that a clip tool which will work on one vehicle will not necessarily work on another vehicle. The reason is because each vehicle has clips that are different sizes or have a different size opening for you to access the release part of the clip. Our new JLT656 is designed to work on a wide range of Honda and Acura vehicles with smaller or narrower openings than some of the older clips. Its thin design allows it to work on the Accord (2003 and up), the Civic (2001 and up), the Odyssey (2005 and up), Acura RL (2005 and up), Acura TL (2005 and up), and the Acura TSX (2005 and up). These vehicles are some of the most popular in America and are encountered daily by technicians. The clip remover jaws are 1-1/8" inside and each clip release jaw is 1/8" wide. It is made of 1/16" thick hardened stainless steel.