It is not very often that we discontinue an item and then receive the volume of calls we received asking us to bring it back, however the Razorback™ is one of those items. It seems we made the decision to discontinue it just at the time technicians were beginning to realize how important the design was. So, It’s back!
The Razorback™’s blades are ground with a slight back angle that keeps you from scratching the bottom or sides of the pinchweld. This allows you to leave a small amount of urethane on the pinchweld, as recommended by urethane manufacturers. The corners are rounded so they will not scratch the bottom corner of the pinchweld. On some vehicles the headliner lays against the windshield just below the pinchweld. Often the headliner overlaps onto the pinchweld and is stuck in place with urethane. By using the proper width blade, Razorback™ can trim up against the headliner and leave the old urethane attached to the headliner. Razorback™ comes as a kit with pinchweld cleaners in the following widths: 1-1/4", 1", 3/4", 1/2". Also included is one below-the-fender pinchweld cleaner and one round file. With the round file you can keep the blades sharp even into the rounded corners. All the pinchweld cleaners and file fit neatly into a canvas pouch that folds over at the top of the tools and seals tightly closed with a Velcro® latch.