Also works on Nissan Maxima and many others. The trend in recent years is to create a clip that can be pushed down to different levels and lock in place. This corrects any uneven fit between the moulding and the glass. It works great when you are installing the moulding and it needs to be a little higher or a little lower, but it becomes a problem when you must remove the clip. Each time you release one holding tab it catches on the next one and must be released from it. There can be as many as 5 of these holding tabs. Our Clip Remover is very thin on the front and edge to allow it to slip between the tabs on the clip and the receiver clip. Pry up slightly, and all the locking tabs are held apart while the moulding is lifted out. Made of high-quality hardened steel.